SLOPE INDICATOR - MAGNET EXTENSOMETER

Application

The magnet extensometer is used to monitor settlement and heave in excavations, foundations, dams, and embankments. It can also be installed behind retaining structures, such as sheet piles and slurry walls, and above underground openings, such as tunnels and shafts. Data from the extensometer indicate the depths at which settlement has occurred as well as the total amount of settlement.

Operation

The system consists of a probe, a graduated cable, a tape reel with built-in light and buzzer, and a number of magnets positioned along the length of an access pipe. The magnets are coupled to the surrounding soil and move up or down as heave or settlement occurs. Readings are obtained by drawing the probe through the access pipe to find the depth of the magnets. When the probe enters a magnetic field, a reed switch closes, activating the light and buzzer. The operator then refers to the graduations on the cable and notes the depth of the magnet.

When the access pipe is anchored in stable ground, the depth of each magnet is referenced to a datum magnet that is fixed to the bottom of the access pipe. If the bottom of the access pipe is not in stable ground, the depths of the magnets must be referenced to the top of the pipe, which is optically surveyed before readings are taken.

Installed Components

Access Pipe: Inclinometer casing or one-inch access pipe can be used. After pipe and magnets are installed, the borehole is backfilled with grout.

Datum Magnet: The datum magnet is fixed directly to the bottom section of access pipe to serve as a reference. A datum magnet is used when the bottom of the pipe is anchored in stable ground.

Spider Magnet: The spider magnet, named for its spring-steel legs, is used in boreholes. The legs are compressed for installation and are released when the magnet is positioned at the specified depth. The spider magnet is typically attached to the access pipe prior to installation, but can also be pushed into place after the pipe is installed.

Plate Magnet: The plate magnet is used in fill. It is positioned at the specified elevation and then covered with fill material that is compacted to the same specifications as the surrounding fill.

Telescoping Sections: Telescoping sections are installed when settlement or heave is expected to exceed 3%.

Easy to handle: Instead of a measuring tape, the magnet extensometer uses a graduated cable that is easy to handle and winds up neatly. The cable is 3.5 mm (0.125") in diameter and has twin steel conductors inside for good dimentional stability. The polyurethane cable jacket is flexible and has very high resistance to abrasion. Graduations on the cable jacket are marked by a laser and are as durable as the cable jacket itself.

Accurate: Readings are typically repeatable to +/- 3 mm ( +/- 0.1 inch). Greater precision can be achieved by building a reference stand that incorporates a vernier dial gauge.